Front Axle Toe, Adjusting

Front Axle Toe, Adjusting

- To loosen or tighten lock nut - B -, counter hold at tie rod end - A - with a wrench.






- Loosen lock nut - B -.

- Adjust toe on left and right-hand wheels with hex - C -.

• Make sure that boot on steering gear is not damaged or twisted. Twisted boots wear out quickly.

• Only tighten lock nuts when vehicle is resting on ground - tie rod end must be parallel to suspension strut steering lever.

- Tighten lock nut - B - and check toe-in value again.

After tightening lock nut - B - it is possible that the value deviates slightly.

If the measured toe nevertheless lies within the tolerance, the adjustment is correct.

Tightening specifications, refer to => [ Steering Gear Overview ] Steering Gear Overview