Throttle Valve Control Module (J338)

Throttle Valve Control Module (J338)

Removing

- Remove engine cover.

- Remove noise insulation.

- Loosen the screw-type clamps - upper arrows -, remove the screws - lower arrows - and remove the charge air pipe and hose downward.






- Disconnect the electrical connector - 1 - from the throttle valve control module.

- Remove the four bolts - arrows - on the throttle valve control module and then remove the throttle valve control module.






Installing

- Install in reverse order of removal.

- Clean the sealing ring surface.

- Replace seal.

• Tightening specifications, refer to => [ Intake Manifold Overview ] Intake Manifold Overview.

- After replacing the throttle valve control module, it must be adapted to the Engine Control Module (ECM) (J623). Use a vehicle diagnosis tester.