Defect Code 03
Defect Code 03:
Explanation:
Defect on the connection link (interface) to the DME (ignition timing adjustment)
Possible cause:
Short or break on the wire to the DME control unit
Troubleshooting:
Switch off ignition and detach control unit connector.
Check ZWV wire from ABS/ASC+T Pin 39 to the DME and repair If necessary.
Connect control unit and switch on ignition.
Read out ignition angle (dynamic) by way of the DME diagnostic program *D* 200 Status monitoring for both DME control units.
Simulate ASC+T control mode; the ignition angle must be set towards retard.
If the ignition timing is not adjusted, there is a defect either in the ABS/ASC+T or in a DME control unit.
________________________________
*D*: Diagnostic Mode; Connect the BMW DIAGNOSTIC SYSTEM to the vehicle. Select control unit and set up diagnostic mode with the control unit.