Ignition Coil: Service and Repair

12 13 511 - Replacing ignition coils (N52, N52K, N51)





Necessary preliminary tasks:
- Read out fault memory of DME control unit.
- Check stored fault messages
- Switch off ignition
- Remove ignition coil cover 11 00 ... Removing and Installing/Replacing Acoustic Cover





Unlock plug retainer of ignition coil (1) and disconnect plug.
Pull ignition coil (1) up and out.
This procedure is applicable to all ignition coils.





Installation:
Check that rubber seal of ignition coil (1) is correctly seated.





Installation:
Push plug (1) with plug retainer (2) open onto ignition coil.
Carefully close plug retainer (2) in direction of arrow.





Installation:
The plug retainer must snap into place without great effort.





Note:
Now clear the fault memory.