Traction Active Indicator On With No DTC Set

CIRCUIT DESCRIPTION
The TRACTION ACTIVE indicator is controlled by the EBCM/EBTCM via serial data UART.

DIAGNOSTIC AIDS
^ It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the malfunction.
^ An intermittent malfunction can be caused by poor connections, broken insulation, or a wire that is broken inside the insulation.
^ If an intermittent malfunction exists, refer to Intermittents and Poor Connections Diagnosis.

TEST DESCRIPTION
The number below refer to the step number on the diagnostic table.
2. This step inspects if the instrument cluster has the ability to turn the indicator off.