Steering Linkage Outer Tie Rod Replacement

Steering Linkage Outer Tie Rod Replacement

Special Tools

J 24319-B Universal Steering Linkage Puller

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).




3. Remove the prevailing torque nut (2) from the outer tie rod assembly (1).




4. Loosen the jam nut (2) on the inner tie rod assembly (1).





Caution: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.

5. Remove the outer tie rod assembly from the steering knuckle using J 24319-B .




6. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

Installation Procedure




1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).




2. Install the outer tie rod assembly (2) to the steering knuckle (1).





Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the prevailing torque nut (2) to the outer tie rod assembly (1).

Tighten the nut to 30 Nm plus 120 degrees (22 lb ft plus 120 degrees). Inspect to ensure that 21/2-41/2 threads are visible above the nylon washer.

4. Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
5. Lower the vehicle.
6. Perform a front end alignment. Refer to Wheel Alignment Measurement (Service and Repair).