Turn Signal Switch Housing Replacement

Turn Signal Switch Housing Replacement

Removal Procedure




Warning: Refer to SIR Warning (SIR Warning).

1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).
2. Remove the tilt head components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).
3. Remove the turn signal and multifunction switch assembly only. Refer to Turn Signal Multifunction Switch Replacement (Turn Signal Multifunction Switch Replacement).
4. Slide the turn signal switch housing off of the steering column shaft assembly.

Installation Procedure





Note: The switch mounting bracket must be pressed firmly against the steering column tilt head.

1. Slide the turn signal switch housing onto the steering column shaft assembly.
2. Install the turn signal and multifunction switch assembly only. Refer to Turn Signal Multifunction Switch Replacement (Turn Signal Multifunction Switch Replacement).
3. Install the tilt head components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).
4. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).