Idle Speed/Throttle Actuator - Electronic: Service and Repair
REMOVAL PROCEDUREDescription:
1. Disconnect the IAC electrical connector (1) from the IAC valve.
Description:
2. Remove the 2 IAC valve attaching screws (4).
3. Remove the IAC valve (1) from the throttle body.
4. Remove the IAC valve O-ring.
INSTALLATION PROCEDURE
Description:
1. Install the new IAC O-ring.
2. Install the IAC valve (1) into the throttle body.
3. Reinstall the screws into the IAC valve.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Tighten
Tighten the screws (4) to 3 N.m (27 lb in).
Description:
4. Connect the IAC valve electrical connector (1) to the IAC valve.