Service Bay Test

DESCRIPTION
The EVAP Service Bay Test raises the engine coolant temperature (ECT) upper limit so that the EVAP diagnostic tests can run while in a service environment. The EVAP service bay test can be used to verify an existing condition or verify that the EVAP system is OK. The scan tool will display a specific DTC code failure or system passed.

CONDITIONS FOR RUNNING THE TEST

IMPORTANT: The following conditions must be met in order to enable the Service Bay Test:

1. The ignition is ON.
2. The ignition voltage is between 9-18.0 volts.
3. The engine coolant temperature (ECT) is less than 50°C (122°F)
4. The fuel level is between 15-85 percent of capacity.
5. The vehicle speed is less than 4.8 km/h (3 mph).
6. The stored DTCs have been cleared.

TEST PROCEDURE
1. Install a scan tool.
2. With a scan tool, select the service bay test in the special functions menu.
3. Follow the instructions on the scan tool.
4. Continue with the diagnostic DTC procedure.