Operation CHARM: Car repair manuals for everyone.

Garnish Molding Replacement - Front Door Frame



Garnish Molding Replacement - Front Door Frame

Removal Procedure

1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair).




2. Disconnect the electrical connector.
3. Remove the wiring harness from the retaining clip.
4. Remove the door frame garnish molding (1) by pulling the molding away from the door window opening flange.



Installation Procedure






Important: Reinstall any clips that were pulled off the garnish molding (1), and replace any broken clips if the garnish molding is going to be reused.


1. Install the door frame garnish molding (1) to the window opening.
2. Engage the clips to the door inner panel flange.
3. Install the two push pins into the locator holes in the door panel at each end of the garnish molding.
4. Secure the wiring harness into the retaining clip.
5. Connect the electrical connector.
6. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair).