Armrest Pull Cup Replacement

Armrest Pull Cup Replacement (Impala)

Removal Procedure




1. Remove the screws from the front and/or rear door armrest pull cup

Notice: Apply protective coating/tape at the insertion point of the small flat-bladed tool in order to prevent damage to the inner door trim panel.

2. Remove the front and/or rear door armrest pull cup from the inner door trim panel using a small flat-bladed tool at the front of the front and/or rear door armrest pull cup and press rearward in order to release the clip retainer.
3. Remove the front and/or rear door armrest pull cup from the front and/or rear inner door trim panel.
4. Remove the front door power mirror switch from the front door armrest pull cup.
5. Remove the front and/or rear door power window switch from the front and/or rear door armrest pull cup.


Installation Procedure




1. Install the front door power mirror switch to the front door armrest pull cup. Refer to Power Mirror Switch Replacement (Impala).
2. Install the front and/or rear door armrest power window switch to the front and/or rear door armrest pull cup.


3. Install the front and/or rear door armrest pull cup to the front and/or rear inner door trim panel pressing into place until fully seated.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the screws to the front and/or rear door armrest pull cup

Tighten the screws to the front and/or rear door armrest pull cup to 6 Nm (53 lb in).