Valve Cover: Service and Repair
Camshaft Cover ReplacementRemoval Procedure
1. Disconnect the negative battery cable.
2. Remove the air outlet resonator.
3. Remove the accelerator and cruise control cables bracket.
4. Remove the PCV hose.
5. Remove the fuel line brackets.
6. Remove the brake booster hose/pipe from its bracket.
7. Remove the ignition coil and module assembly.
8. Remove the ground strap.
9. Remove the camshaft cover bolts.
10. Remove the camshaft cover.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the camshaft cover and bolts.
^ Tighten the camshaft bolts to 10 Nm (89 inch lbs.).
2. Install the ground strap.
^ Tighten the ground strap bolt to 10 Nm (89 inch lbs.).
3. Install the ignition coil and module assembly.
^ Tighten the ignition coil and module assembly bolt to 10 Nm (89 inch lbs.).
4. Install the brake booster hose/pipe to its bracket.
5. Install the fuel line bracket.
^ Tighten the fuel line bracket bolt to 10 Nm (89 inch lbs.).
6. Install the accelerator and cruise control cables bracket.
^ Tighten the accelerator and cruise control cables bracket bolt to 10 Nm (89 inch lbs.).
7. Connect the negative battery cable.