Ignition Lock Cylinder Case

Ignition Lock Cylinder Case Replacement

Removal Procedure
1. Remove the steering wheel.
2. Remove the steering column trim covers.





3. Remove the inflatable restraint steering wheel module.





4. If applicable, disconnect the ignition lock cylinder solenoid harness connector.
5. Disconnect the ignition switch harness connector.





6. Using the following procedure, remove the ignition lock cylinder case shear bolt:
1. Use a hammer and chisel to bite into the shear bolt at a position offset from center.
2. Tap the chisel to rotate the bolt in order to loosen it. Repeat as necessary until bolt is loose enough to remove.





7. Remove the ignition lock cylinder case housing from the steering column.
8. Remove the ignition lock cylinder from the lock cylinder case housing.

Installation Procedure
1. Install the ignition lock cylinder into the lock cylinder housing.





2. Install the lock cylinder case housing to the steering column.





3. Install the lock cylinder case housing clamp and a new shear bolt. Ensure the tab is correctly positioned.

4. Important: Ensure the lock cylinder case mounting clamp tab is properly installed. Rock the lock cylinder case back and forth to ensure it is seated into the lock bolt cutout.

^ Tighten the shear bolt until the head breaks off.





5. If applicable, connect the ignition lock cylinder solenoid harness connector.
6. Connect the ignition switch harness connector to the lock module.





7. Install the inflatable restraint steering wheel module.
8. Install the steering column trim covers.
9. Install the steering wheel.