Front Bumper Fascia Replacement

Front Bumper Fascia Replacement


Removal Procedure

1.Remove the front bumper fascia opening lower cover. Refer to Front Bumper Fascia Opening Lower Cover Replacement .





2.Remove the front bumper fascia upper bolts (1).

3.Remove the front bumper fascia upper retainers (2).





4.Remove the front wheelhouse liner bolts (1) on both sides.





5.If equipped, remove the lower stiffener bolts (1).





Note:Use a plastic trim tool if necessary. Use care when removing the fascia. Fascia might rip apart if forced.

6.Pull the front bumper fascia (1) carefully outward in order to release the retaining tabs from front bumper fascia guides.

7.Disconnect any electrical connectors.





8.With the aid of an assistant remove the front bumper fascia (1).

9.Transfer or replace parts as needed.

Installation Procedure





1.With the aid of an assistant install the front bumper fascia (1).

2.Carefully push in the retaining tabs of front bumper fascia into the front bumper fascia guides.

3.Connect any electrical connectors.

Caution:Refer to Fastener Caution .





4.If equipped, install the lower stiffener bolts (1) and tighten to2.5 N �m (22 lb in).





5.Install the front wheelhouse liner bolts (1) and tighten to2.5 N �m (22 lb in).





6.Install the front bumper fascia upper retainers (2).

7.Install the front bumper fascia upper bolts (1) and tighten to9 N �m (80 lb in).

8.Install the front bumper fascia opening lower cover. Refer to Front Bumper Fascia Opening Lower Cover Replacement .