30. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools
* EN-652 - Flywheel Holder
* EN-45059 - Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools (Special Tools).




1. Install the EN-652 - holder (1), lock the flywheel (2) or the automatic transmission flex plate via the starter ring gear.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the crankshaft balancer (2) and a NEW bolt (1) and tighten in 3 passes using the EN-45059 - sensor kit :

1. First pass to 95 Nm (70 lb ft).
2. Second pass to 45°.
3. Third pass to 15°.