Transmission Control Replacement

Transmission Control Replacement

Removal Procedure

Warning:
Refer to Safety Glasses Warning Safety Glasses Warning.


1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the exhaust crossover pipe. Refer to Exhaust Crossover Pipe Replacement Service and Repair





3. Remove the shift control linkage adjustment nut.

4. Disconnect the shift control linkage rod from the shift control assembly (1).





5. Remove the shift control assembly to the tunnel reinforcement retaining nuts (2).

6. Lower the vehicle.

7. On vehicles equipped with 9C3, remove the front floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement.

8. On vehicles equipped with 9C1, remove the front floor console front cover. Refer to Front Floor Console Front Cover Replacement (9C1) Front Floor Console Front Cover Replacement (9C1).

9. On vehicles equipped with 9C1, position the park brake cable out of the way.

10. On vehicles equipped with 9C1, remove the left front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Right Side (9C3) Front Floor Console Side Cover Replacement - Right Side (9C3)Front Floor Console Side Cover Replacement - Right Side (9C1) Front Floor Console Side Cover Replacement - Right Side (9C1).

11. On vehicles equipped with 9C1, remove the right front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Left Side (9C1) Front Floor Console Side Cover Replacement - Left Side (9C1)Front Floor Console Side Cover Replacement - Left Side (9C3) Front Floor Console Side Cover Replacement - Left Side (9C3).

12. On vehicles equipped with 9C1, remove the two lower support bracket to transmission control screws.





13. On all vehicles, disconnect the electrical connector (1) from the shift control assembly.

14. Remove the shift control assembly (1) from the tunnel reinforcement.

Installation Procedure





1. Install the shift control assembly (1) to the tunnel reinforcement.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the shift control assembly to the tunnel reinforcement retaining nuts (2) and tighten to 9 Nm (80 lb in).

3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.





4. Connect the shift control linkage rod to the shift control assembly (1).

5. Install the shift control linkage adjustment nut finger tight.

6. Adjust the shift control linkage. Refer to Range Selector Lever Link Adjustment Adjustments.

7. Lower the vehicle.





8. Install the electrical connector (1) to the shift control assembly.

9. On vehicles equipped with 9C3, install the front floor console. Refer to Front Floor Console Replacement Front Floor Console Replacement.

10. On vehicles equipped with 9C1, install the front floor console front cover. Refer to Front Floor Console Front Cover Replacement (9C1) Front Floor Console Front Cover Replacement (9C1).

11. On vehicles equipped with 9C1, position the park brake cable in the transmission control.

12. On vehicles equipped with 9C1, install the two lower support bracket to transmission control screws.

13. On vehicles equipped with 9C1, install the left front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Right Side (9C3) Front Floor Console Side Cover Replacement - Right Side (9C3)Front Floor Console Side Cover Replacement - Right Side (9C1) Front Floor Console Side Cover Replacement - Right Side (9C1).

14. On vehicles equipped with 9C1, install the right front floor console side cover. Refer to Front Floor Console Side Cover Replacement - Left Side (9C1) Front Floor Console Side Cover Replacement - Left Side (9C1)Front Floor Console Side Cover Replacement - Left Side (9C3) Front Floor Console Side Cover Replacement - Left Side (9C3).

15. Install the exhaust crossover pipe. Refer to Exhaust Crossover Pipe Replacement Service and Repair.

16. Verify correct operation of the transmission control.