Ignition Lock Cylinder Replacement (Without BTM)

Ignition Lock Cylinder Replacement (Without BTM)

Removal Procedure

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

2. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement Steering Column Upper Trim Cover Replacement.

3. Remove the ignition lock cylinder bezel. Refer to Ignition Lock Cylinder Bezel Replacement (Without BTM) Ignition Lock Cylinder Bezel Replacement (Without BTM).





4. Insert the key into the ignition lock cylinder (1) and turn the key to the RUN position.





5. Push a pick-type tool into the access hole (1) in the ignition and start switch housing and press the ignition lock cylinder lock tab down.

6. Remove the ignition lock cylinder from the lock housing.

Installation Procedure

1. If you are installing a new ignition lock cylinder, code the lock cylinder. Refer to Lock Cylinder Coding - Ignition Lock Cylinder Coding - Ignition.





2. Turn the key to the RUN position and insert the ignition lock cylinder (1) into the ignition and start switch housing.

3. Turn the key to the LOCK position and remove the key from the ignition lock cylinder.

4. Install the ignition lock cylinder bezel. Refer to Ignition Lock Cylinder Bezel Replacement (Without BTM) Ignition Lock Cylinder Bezel Replacement (Without BTM).

5. Install the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement Steering Column Upper Trim Cover Replacement.

6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.