Parking Assist Control Module: Testing and Inspection

Object Alarm Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

Parking Assist Control Module Replacement

If the parking assist control module needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS.

2. Perform the SPS function Parking Assist Control Module Programming and follow the on-screen instructions.

3. Perform the SPS function Parking Assist Control Module Configuration & Setup and follow the on-screen instructions.

4. Clear DTCs after completing the programming procedure.

Parking Assist Control Module Reprogramming

Do not reprogram the parking assist control module, unless directed by a service procedure, or a service bulletin.

1. Connect a scan tool to the vehicle and access SPS.

2. Perform the SPS function Parking Assist Control Module Programming and follow the on-screen instructions.

3. Clear DTCs after completing the programming procedure.