Operation CHARM: Car repair manuals for everyone.

Armrest Replacement - Rear Seat (YC7)



Armrest Replacement - Rear Seat (YC7)

Removal Procedure

1. Place the seat back in the fully-upright position.




2. Release the J-hook along the bottom edge of the seat back.
3. Reach up inside the seat back. Remove the armrest retaining clip.
4. Slide the armrest assembly out of the seat back.
5. Remove the armrest cover for cleaning or replacement, if needed:

1. Unzip the cover.
2. Slide the cover off the armrest.




Installation Procedure

1. Install the armrest cover to the armrest, if you removed the cover.
2. Reach inside the seat back. Install the armrest retaining clip:

* Install the clip with the opening facing down.
* Check the fit of the clip once installed. If the clip is loose when fitted in the groove in the seat back frame, remove the clip and crimp the clip closed slightly.
Repeat this procedure until the clip fits snugly in the groove, or install a new clip.

3. Insert the armrest into the seat back until the clip engages the groove on the armrest post.
4. Pull on the armrest in order to verify that the clip is holding the armrest securely.




5. Attach the halves of the J-hook along the bottom edge of the seat back.