Keyless Entry System Inoperative

Keyless Entry System Inoperative

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The keyless entry system is a vehicle entry device. The keyless entry system will unlock the vehicle doors or open the trunk when a corresponding button on the keyless entry transmitter is pressed. This is accomplished by the transmitter sending a radio frequency to the remote control door lock receiver (RCDLR). The RCDLR interprets the signal and activates the requested function via a message over the serial data line. A low transmitter battery or radio frequency (RF) interference from aftermarket devices such as 2-way radios, power inverters, cellular phone chargers, computers, etc. may cause a system malfunction. High RF traffic areas, such as gas stations which use pay-at-the-pump RF transponders, may also cause interference that could lead to a malfunction.

Diagnostic Aids

For the J 43241 Keyless Entry Tester, inspect the keyless entry transmitter part number to determine that it is the correct model for the vehicle. An incorrect transmitter may pass the test, but it will not activate the keyless entry system.

Reference Information
Schematic Reference

Remote Function Schematics [1][2]Electrical Diagrams
Connector End View Reference

Component Connector End Views
Description and Operation

Keyless Entry System Description and Operation Description and Operation
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for Scan Tool Information
Special Tools

J 43241 Keyless Entry Tester

Circuit/System Verification

1. Verify that the transmitter is the correct transmitter for the vehicle.

• If not the correct transmitter, replace the transmitter.

2. Place the transmitter on the test pad of the J 43241 and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.

• If one or more buttons does not sound the tone and illuminate the green light, replace the transmitter battery and retest with the J 43241 . If the condition continues after battery replacement, replace the transmitter.

3. Operate the transmitter while observing the scan tool Fob Function parameter for the appropriate transmitter. The parameter should correspond with the function selected on the transmitter.

• If the parameter does not match the function selected on the transmitter, program the transmitter and retest. Refer to Transmitter Programming Testing and Inspection. If the condition continues after transmitter programming, replace the transmitter.

4. If all circuits test normal, replace the RCDLR.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for RCDLR replacement, setup, and programming