Actuator: Service and Repair

Front Drive Axle Actuator Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the engine shield, if equipped. Refer to Engine Shield Replacement (Engine Shield Replacement).
3. Disconnect the electrical connector from the actuator.




4. Remove the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.5 inch axle (4) by turning the actuator counterclockwise.

Installation Procedure




1. Apply sealant to the threads of the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.25 inch axle (4). Use the correct sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers (Fluid Type Specifications).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the actuator (1 or 3).

Tighten the actuator to 20 Nm (15 lb ft).

3. Connect the electrical connector to the actuator.
4. Install the engine shield, if equipped. Refer to Engine Shield Replacement (Engine Shield Replacement).
5. Lower the vehicle.