Turbocharger Vane Position Sensor Replacement

Turbocharger Vane Position Sensor Replacement

Removal Procedure




1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement (Intake Manifold Cover Replacement).

Note: Note the routing of the turbocharger vane position sensor pigtail prior to removal.

2. Disconnect the engine wiring harness electrical connector (1) from the turbocharger vane position sensor electrical connector (2).




3. Remove the turbocharger vane position sensor electrical connector clips from the wiring harness bracket.
4. Remove the thermal reflective shield/tape from the vane position sensor, if required.
5. Remove the turbocharger vane position sensor from the turbocharger.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the turbocharger vane position sensor to the turbocharger.

Tighten the sensor to 28 Nm (21 lb ft).

2. Install the turbocharger vane position sensor electrical connector clips to the wiring harness bracket.




3. Connect the engine wiring harness electrical connector (1) to the turbocharger vane position sensor electrical connector (1).