Operation CHARM: Car repair manuals for everyone.
Home >> Chevy Truck >> 2011 >> Silverado 2500 4WD V8-6.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Camshaft, Lifters and Push Rods >> Camshaft >> Service and Repair >> Camshaft Position Actuator Magnet Replacement

Camshaft Position Actuator Magnet Replacement




Camshaft Position Actuator Magnet Replacement

Removal Procedure




1. Remove the water pump. Refer to Water Pump Replacement (V8) (Water Pump Replacement)Water Pump Replacement (Diesel) (Water Pump Replacement)Water Pump Replacement (V6) (Water Pump Replacement).
2. Disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet.
3. Remove the CMP actuator magnet bolts (751) and magnet (752).
4. Remove and discard the CMP actuator magnet gasket (753).

Installation Procedure





Note: The gasket surface should be free of oil or other foreign material during assembly.

1. Install a NEW CMP actuator magnet gasket (753) onto the CMP actuator magnet.
2. Install the CMP actuator magnet (752) to the front cover.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CMP actuator magnet bolts (751) and tighten to 12 Nm (106 lb in).
4. Connect the engine harness electrical connector to the CMP actuator magnet.
5. Install the water pump. Refer to Water Pump Replacement (V8) (Water Pump Replacement)Water Pump Replacement (Diesel) (Water Pump Replacement)Water Pump Replacement (V6) (Water Pump Replacement).

pro multis · About Operation CHARM