Rear Brake Caliper Bracket Replacement (J90, J95, J96)

Rear Brake Caliper Bracket Replacement (J90, J95, J96)

Removal Procedure

Warning:
Refer to Brake Dust Warning Brake Dust Warning.


1. Remove the rear disc brake pads. Refer to Rear Disc Brake Pads Replacement (J90, J95, J96) Rear Disc Brake Pads Replacement (J90, J95, J96)Rear Disc Brake Pads Replacement (JD9) Rear Disc Brake Pads Replacement (JD9).





2. Remove the rear brake caliper bracket (1).





Note:
The upper brake caliper guide pin is equipped with a bushing and must be installed in the same position.

3. Remove the upper brake caliper guide pin (1).

4. Remove the lower brake caliper guide pin (2).

5. Remove the brake caliper guide pin collars (3).

Installation Procedure

1. Apply a light coat of high temperature silicone brake lubricant to the brake caliper guide pin surfaces and the brake caliper guide pin bores:

* Apply lubricant to the brake caliper guide pin shafts.

* Apply lubricant to the brake caliper guide pin seals.





Note:
The upper brake caliper guide pin is equipped with a bushing and must be installed in the same position.

2. Install the upper brake caliper guide pin (1), the lower brake caliper guide pin (2), and the brake caliper guide pin collars (3).

Caution:
Refer to Fastener Caution Fastener Caution.

3. Tighten the brake caliper guide pins to 105 Nm (77 lb ft).





4. Install the rear brake caliper bracket (1).

5. Ensure the brake caliper guide pin seals are fully seated in the grooves on the brake caliper and the brake caliper bracket.

6. Install the rear disc brake pads. Refer to Rear Disc Brake Pads Replacement (J90, J95, J96) Rear Disc Brake Pads Replacement (J90, J95, J96)Rear Disc Brake Pads Replacement (JD9) Rear Disc Brake Pads Replacement (JD9).