Body Verification Test

BODY VERIFICATION TEST - VER 1

Diagnostic Test

1. Perform Body Verification Test

NOTE: If the SKREEM or PCM/ECM was replaced, refer to the service information for proper programming procedures.

NOTE: PT27 ONLY: If a Window Regulator Module was replaced, close both doors, raise both door windows fully up and hold the switch in the up position for 2 additional seconds then use the scan tool to "Initialize Module".
- Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
- Ensure that all accessories are turned off.
- Ensure that the battery is fully charged.
- Turn the ignition on.
- With the scan tool, record and erase DTC's from all modules.
- If an electronic control module was replaced, select the applicable module from the scan tool menu and press "Misc. Functions". If the module has programmable features, program as necessary.
- (Export only) If the Intrusion Transceiver Module (ITM) and/or Siren was replaced, select ITM from the scan tool ECU View menu then "Misc. Functions" and perform the applicable replacement procedure.
- Turn the ignition off, wait 10 seconds, and then turn the ignition on.
- Operate all functions of the system that caused the original concern. If a repair or module replacement was done to the front power windows on a PT27, operate the motor fully down and then to the full up position and stall it for 2 seconds.
- With the scan tool, select ECU View and check for DTC's in the modules.

Are DTCs present in any of the modules or is the original condition still present?

Yes

- The repair is not complete. Refer to the related category for the DTC or symptom that is still present.

No

- The repair is complete.