Sunroof Motor With Control Unit - Removal

REMOVAL

NOTE: The sunroof system is timed from the factory so that the motor/module shuts off automatically when the sunroof window reaches a certain position. Extreme care must be taken when removing the motor/module from the sunroof assembly or this timing may be thrown off causing damage to the sunroof system. Anytime the motor/module needs to be removed from the sunroof assembly the sunroof window must be in the FULLY CLOSED POSITION if possible.
If glass panel is not in the fully closed position and the motor/module is removed or inoperative, Power Sunroof Timing.


1. Disconnect and isolate the negative battery cable.
2. Remove A-pillar trim A-Pillar Trim Panel-Removal.
3. Remove sun visors Sun Visor - Removal.
4. Remove map lamps/mini console, Removal.
5. Remove the sunroof switch, Sunroof Switch - Removal.
6. Remove sunroof opening trim lace. Removal.
7. Remove headliner as necessary to gain access to sunroof motor/module. Headliner - Removal.
8. Disconnect the motor/module wire harness connectors.
9. Remove the motor/module attaching screws.
10. Remove motor/module from the sunroof housing assembly.