Power Steering Pump - Removal

2.4L TURBO

NOTE: Before proceeding, Service Precautions.

1. Siphon as much fluid as possible from power steering fluid reservoir.
2. Raise and support the vehicle. Service and Repair
3. Drain the engine coolant.




4. Remove the wheel mounting nuts (3), then the right front tire and wheel assembly (1).




5. Disconnect the radiator fan wiring connector (1).




6. Remove the two lower fan mounting screws (1).




7. Remove the one fastener (2) securing the wheel house splash shield (1) to the drive belt splash shield (3).




NOTE: Depending on application, it may be necessary to remove some fasteners securing the front fascia (1) to the body lower reinforcement in order to access drive belt splash shield forward fastener.

8. Remove the fastener (5) securing the drive belt splash shield (3) to the front suspension crossmember (6).
9. Remove the fasteners (4) securing the splash shield (3) to the body (2).
10. Remove the drive belt splash shield (3).
11. Remove the accessory drive belt. Accessory Drive Belt - Removal
12. Lower the vehicle.




13. Remove the grille (1) from the front of the vehicle. Grille - Removal
14. Remove the hood-opening weather-strip from across the radiator closure panel.




15. Remove the ambient temperature sensors (1, 2) from the radiator closure panel.




16. Remove the fasteners (1) securing the upper radiator closure panel in place, then remove the panel and lay it out of way.




17. Remove the two screws (1) fastening the upper radiator hose inlet neck (2) to the radiator, then separate the inlet neck from the radiator.
18. Carefully tip the top of the cooling module toward the front of the vehicle. DO NOT FORCE IT. Using a bungee cord or equivalent, tie the module forward in this position. Be sure to attach the cord in a location that will not damage the vehicle. Do not overtighten the bungee cord. It just needs to hold the module forward.




19. Remove remaining four screws (1) fastening the radiator fan to the cooling module. Remove the fan.




20. Remove the clamp securing the return hose (3 ) to the pump reservoir (1), then remove the hose from the reservoir fitting. Cap off the hose end and reservoir fitting.
21. Unscrew the tube nut (5) securing the pressure hose (2) to the power steering pump (6) and remove the hose from the pump. Cap off the hose end and pump pressure port.




22. Remove the three mounting bolts securing the power steering pump in place.




23. Remove the two bolts securing the stamped steel support bracket to the engine block. Remove the bracket.
24. Remove the power steering pump with pulley and reservoir attached.
25. If the pulley needs removal, Power Steering Pump Pulley - Removal.