Catalytic Converter - Installation

INSTALLATION - FRONT EXHAUST PIPES





NOTE: Inspect the exhaust manifold flange surface. Replace as required.

1. Install bolts at right side exhaust pipe flange (11). Tighten to 20 Nm (15 ft. lbs.).
2. Position and support the front exhaust pipes in the vehicle.
3. Install bolts at the left and right exhaust manifold (8 and 9) flanges.
4. Install bolts at the center exhaust manifold flange (3).
5. Tighten exhaust manifold flange bolts to 20 Nm (15 ft. lbs.).
6. Tighten bolts at the center exhaust pipe flange to 20 Nm (15 ft. lbs.).
7. Connect oxygen sensor wiring harness connectors (6 and 7).
8. Route oxygen sensor wire harness in harness retainer.
9. Remove exhaust system support.
10. Lower the vehicle.