AS68RC Transmission Verification Test

AS68RC TRANSMISSION VERIFICATION TEST

For a complete wiring diagram refer to Diagrams/Electrical. Electrical Diagrams

Perform the following after completion of a diagnostic repair:
- Reconnect any disconnected components.
- Connect the scan tool to the Data Link Connector (DLC).
- With the scan tool, erase all Transmission and Engine DTCs.
- With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT.
- Check the Transmission fluid level and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
- Road test the vehicle allowing the vehicle to shift through all gears.
- Check for DTCs during and after the road test.

Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

Yes

- Refer to the Transmission category and perform the appropriate symptom.

No

- Repair is complete.