Front Steering Knuckle - Installation

INSTALLATION





CAUTION: The ball joint stud tapers must be CLEAN and DRY before installing the knuckle. Clean the stud tapers with mineral spirits to remove dirt and grease.

1. Install the hub/bearing to the steering knuckle and tighten the bolts (1) to 163 Nm (120 ft. lbs.).




2. Install the knuckle (7) onto the upper (2) and lower ball joints (5).
3. Install the upper (1) ball joint nut. Tighten the nut to 95 Nm (70 ft. lbs.).
4. Install the lower ball joint nut (6). Tighten the nut to 129 Nm (95 ft. lbs.).
5. Remove the hydraulic jack from the lower control arm (4).




6. Install the tie rod end (2) and tighten the nut (1) to 108 Nm (80 ft. lbs.).




7. Install the front halfshaft (2) into the hub/bearing 4X4 only.
8. Install the the halfshaft nut and tighten to 251 Nm (185 ft. lbs.) 4X4 only.
9. Install the ABS wheel speed sensor if equipped Front Wheel Speed Sensor - Installation and brake shield, rotor and caliper Brake Rotor - Installation.
10. Install the wheel and tire assembly Removal and Replacement.
11. Remove the support and lower the vehicle.
12. Perform a wheel alignment Service and Repair.