Airbag System Verification Test

AIRBAG SYSTEM VERIFICATION TEST
VERIFICATION TEST
1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the battery.

WARNING: Turn the ignition on, then reconnect the 12-volt battery. Failure to follow these instructions may result in possible serious or fatal injury.

2. Connect the scan tool to the Data Link Connector - use the most current software available.
3. If sent here from an Occupant Classification System (OCS) related diagnostic procedure or if repairs were made to the OCS, perform the OCS Verification Test before proceeding. OCS Verification Test
4. With the scan tool erase stored DTC in the Occupant Restraint Controller (ORC).
5. Turn the ignition off, and wait 1five seconds, then turn the ignition on.
6. Wait one minute, using the scan tool read active ORC DTCs and if there are none present read the stored codes.
7. If the scan tool shows any active or stored codes, follow path specified for that trouble code. If no active or stored codes are present, the repair is complete.

Are any DTCs present or is the original condition still present?

Yes

- Repair is not complete. Testing and Inspection Perform the appropriate diagnostic procedure.

No

- If the battery was disconnected for any reason, you must perform the Battery Reconnection procedure. Battery Reconnection
- Repair is complete.