Body Verification Test

BODY VERIFICATION TEST
Perform Body Verification Test

NOTE: If the Sentry Key remote Entry Module (SKREEM) also known as the Wireless Control Module (WCM) or PCM/ECM was replaced, refer to the Service Information for proper programming procedures.

- Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
- Make sure that all accessories are turned off.
- Make sure that the battery is fully charged.
- Turn the ignition on.
- With the scan tool, record and erase DTCs from all modules.
- If an electronic control module was replaced, select the applicable module from the scan tool menu and press "Misc. Functions". If the module has programmable features, program as necessary.
- (Export only) If the Intrusion Transceiver Module (ITM) and/or Siren was replaced, select ITM from the scan tool ECU View menu then "Misc. Functions" and perform the applicable replacement procedure.
- If the battery was disconnected for any reason, you must perform the Battery Reconnection procedure. Battery Reconnection
- Turn the ignition off, wait 10 seconds, and then turn the ignition on.
- Operate all functions of the system that caused the original concern.
- With the scan tool, select ECU View and check for DTCs in the modules.

Are DTCs present in any of the modules or is the original condition still present?

Yes

- The repair is not complete. Perform the appropriate diagnostic procedure for the DTC or symptom that is still present.

No

- The repair is complete.