Steering Column - Removal

REMOVAL

WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical restraint system for service procedures. Failure to do so may result in accidental deployment of the airbag and possible personal injury.

CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.

NOTE: 1500 series shown, others similar.





1. Position the front wheels straight ahead.
2. Disconnect the negative battery cable from the battery.
3. Remove the airbag Driver Air Bag - Removal.
4. Partially remove the steering wheel bolt (1) and leave the bolt in the column.
5. Install Steering Wheel Puller C-3894-A or equivalent using the top of the bolt to push on, and loosen the steering wheel (2).
6. Remove the tool and steering wheel bolt (1), and discard the steering wheel bolt (1).

NOTE: Route the harness through the steering wheel during removal.

7. Remove the steering wheel (2).
8. Remove the clock spring Clockspring - Removal.
9. Remove the upper and lower column shrouds Steering Column Shroud - Removal.
10. Disconnect the wiring harness routing retainers and connectors to the various components of the steering column.





11. If equipped with a floor shift, remove the shift cable from the routing clip (1).
12. If equipped with a column shift, disconnect the shift cable from the shift assembly lever and remove the cable from the bracket.
13. Remove the brake light switch (3).
14. Remove the upper steering shaft coupler bolt (4) and discard. Separate the shaft from the coupler.
15. Remove the forward steering column mounting nuts (5).
16. Support the steering wheel and remove the forward steering column mounting nuts (2).
17. Remove the steering column assembly from the vehicle.
18. Remove and transfer any necessary components.