Drive Shaft - Installation

INSTALLATION

NOTE: Clean all propeller shaft bolts and apply Mopar(R) Lock AND Seal Adhesive or equivalent to the threads before installation.






CAUTION: Failure to follow these instructions may result in a driveline vibration.

1. Install propeller shaft on transfer case or transmission with reference marks (3) aligned. Install flange bolts and tighten to 108 Nm (80 ft. lbs.).





2. Install center bearing (5). Tighten to 27 Nm (20 ft. lbs.).
3. Install heat shield (3).





4. Install exhaust system Installation.
5. If equipped, install skid plates Skid Plate - Installation