Instrument Panel Glove Box - Removal

REMOVAL

Special Tools:










1. Separate the glove box damper (2) from the clove box by sliding the clip towards the rear of the vehicle to release it from the bin.

NOTE: A small prybar may be used to separate the tabs from the glove box housing.

2. Open the glove box and carefully squeeze the inboard open stop tab (3) inward and separate the tab from the glove box housing.
3. Squeeze the outboard open stop tab (4) inward and separate the tab from the glove box housing and allow the glove box to rotate toward the carpet.
4. Rotate the box down and release the door hinges (1) at the bottom and remove the glove box.





5. Using trim stick or equivalent, remove the passenger side end cap (1).





6. Using (C-4755) or equivalent, release the two rear retaining clips (2).
7. Pull backwards on the owners guide shelf (3) and release the shelf legs from the glove box surround (1) and remove the shelf (3).





8. Remove the glove box surround screws (1).





9. Remove the glove box surround (2) from the instrument panel opening (1).