Sunroof / Moonroof Panel: Adjustments

ADJUSTMENTS





1. Move the sunshade rearward to the open position.
2. Move the sunroof glass panel to the fully closed position.
3. Adjust the glass one corner at a time.
a. Loosen four glass screws (1).
b. Lift glass assembly and align the top of the glass panel to the top of the roof panel.
c. Tighten screw to 3 Nm (26 in. lbs.).
d. Repeat steps a. and b. for each corner of the glass panel.
e. When properly adjusted, the front of the glass panel is 1.0 mm (0.04 in.) to 2.0 mm (0.08 in.) lower than the roof surface and the rear edge of the glass panel is 1.0 mm (0.04 in.) to 2.0 mm (0.08 in.) higher than the roof surface.






NOTE: When properly adjusted, the front of the glass panel (3) is 1.0 mm (0.04 in.) to 2.0 mm (0.08 in.) lower than the roof surface (2).







NOTE: When properly adjusted, the rear edge of the glass panel (3) is 1.0 mm (0.04 in.) to 2.0 mm (0.08 in.) higher than the roof surface (2).

4. Verify sunroof operation and alignment. Check fit and re-adjust as necessary.