Crankshaft Rear Oil Seal Retainer - Installation

INSTALLATION






NOTE: The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE: The crankshaft rear oil seal retainer can not be reused after removal.

1. Thoroughly clean all gasket residue from the engine block.
2. Position the gasket onto the new crankshaft rear oil seal retainer.
3. Position the crankshaft rear oil seal retainer onto the engine block.
4. Using the sequence shown, install the crankshaft rear oil seal retainer mounting bolts and tighten to 15 Nm (11 ft. lbs.).
5. Install the oil pan Engine Oil Pan - Installation
6. Install the flexplate Flexplate - Installation
7. Install the transmission.
8. Fill the engine with oil.
9. Start the engine and check for leaks.