Front Bumper Fascia - Installation

INSTALLATION

Upper







1. Locate the end wings under the headlamp (3) and roll down into position.
2. Position the center locator pin in the center of the fascia to the retainer hole and seat fully.
3. Working from the center out, seat all the clips fully.
4. Install the grille.

NOTE: Sport fascia shown, upper fascia similar.

5. Install the screws (1) attaching the fascia (3) to the fender (2).










6. Position the wheelhouse splash shield back and install the push pins (3).

Sport

1. Locate the fascia (1) over the upper surface of the bumper beam (2).
2. Position the center locator pin in the center of the fascia to the retainer hole and seat fully.
3. Pry or bend the outer ears of the fascia (1) around the headlamps and align to the fender (3).
4. Confirm that the fascia (1) and the bumper (2) are lined up correctly and seat the upper clips fully.
5. Install the grille.










6. Install the four lower fasteners (2).







7. Install the screws (1) attaching the fascia (3) to the fender (2).







8. Position the wheelhouse splash shield back and install the push pins (3).