Body Verification Test

BODY VERIFICATION TEST - VER 1

Diagnostic Test

1. Perform Body Verification Test
Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
If the Body Control Module (BCM) was replaced, with the scan tool, program the country code into the BCM's memory.
Program all RKE Transmitters and other options as necessary.
If any HVAC door actuator circuits were repaired, with the scan tool in HVAC, System Tests, select Actuator Circuit Test.
If any HVAC door actuators were replaced/door linkage was repaired, with the scan tool in HVAC, System Tests, select HVAC Door Recalibration.
Ensure that all accessories are turned off and the battery is fully charged.
With the scan tool, record and erase all DTCs from ALL modules. Start and run the engine for 2 minutes. Operate all functions of the system that caused the original concern.
Turn the ignition off and wait 5 seconds. Turn the ignition on and using the scan tool, read DTCs from ALL modules.
Are DTCs present in any of the modules or is the original condition still present?

Yes

- The repair is not complete. Refer to the related category for the DTC or symptom that is still present.

No

- The repair is complete.