Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Lever, Gearshift - Installation






INSTALLATION





1. Feed the autostick wiring through the hole in the cluster bezel and slide the gear shift lever (2) into the column shift mechanism.

NOTE: Before installing gear shift lever mounting screw, clean screw threads and apply Mopar(R) Lock & Seal Adhesive.

2. Line up the threaded hole in the lever with the hole in the shift mechanism and install the gear shift lever mounting screw (1). Tighten the screw to 12 Nm (106 in. lbs.).





3. Slide the gear shift lever boot down gear shift lever (1) and snap it into place on the cluster bezel (3).





4. Route the autostick wiring (3) along the right side of the column gear shift mechanism and install a wiring tie strap (2) securing the autostick wiring to the column.
5. Connect the autostick wiring connector (1).
6. Check autostick wiring (3), making sure it is routed away from movable portions of shift mechanism.





7. Install the steering column opening reinforcement (1).

8. Install the steering column opening cover. Steering Column Opening Cover - Installation
9. Install the negative battery terminal on the battery. It is important that this is performed properly (including calibration of steering angle sensor if equipped with ESP). Battery Reconnection

CAUTION: If the steering wheel is excessively off-center while driving, outside of Chassis specifications, inadvertent ESP activations may occur on a vehicle so equipped.

10. Test the operation of the gear shift lever and autostick functions.