Seat - Installation

INSTALLATION

1. Before proceeding with the following repair procedure, review all warnings and cautions. Service Precautions

WARNING: The front passenger seat must be handled carefully as well. When removing the seat, be careful when setting on floor not to drop. If dropped, the sensor may be inoperative. Failure to follow these instructions may result in serious or fatal injury.

WARNING: When the seat is on the floor, no one should sit in the front passenger seat. This uneven force may damage the sensing ability of the seat weight sensors. If sat on and damaged, the sensor may be inoperative. Failure to follow these instructions may result in serious or fatal injury.

2. Place seat into position in vehicle.
3. Connect the electrical connectors.
4. Connect battery negative cable.
5. Move the seat forward to gain access to the rear bolts.
6. Install the front seat attaching rear bolts. Tighten bolts to 65 Nm (48 ft. lbs.).
7. Move the seat rearward to gain access to the front bolts.
8. Install the front seat front attaching bolts. Tighten bolts to 65 Nm (48 ft. lbs.).
9. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component. Restraints System Verification Test.