Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2012 >> Charger AWD V8-5.7L >> Repair and Diagnosis >> Starting and Charging >> Starting System >> Starter Motor >> Service and Repair >> Starter - Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Starter - Installation






5.7L ALL WHEEL DRIVE (AWD)





1. Position starter (1) into transmission but do not install bolts (2).





2. Connect the solenoid harness connector (1) to starter motor (snaps on).
3. Position the battery cable to solenoid stud (2). Install and tighten battery cable eyelet nut to 11 Nm (97 In. Lbs). Do not allow starter motor to hang from wire harness.
4. Install and tighten both mounting bolts (4). Tighten the bolts to 54 Nm (40 Ft.Lbs).





5. Install steering gear assembly and mounting bolts (4). [1][2]Specifications for torque specifications.
6. Install the steering gear intermediate shaft (1). Intermediate Shaft - Installation
7. Install steering gear heat-shield.
8. Lower the vehicle.
9. Connect the negative battery cable.

10. Start the engine to verify the starter is functioning properly.
11. Turn the ignition off.
pro multis · About Operation CHARM