DTC 86-2x

DTC 86-1x ("x" can be 0 thru 9 or A thru F) Faulty Seat-back OPDS Sensor

DTC 86-2x ("x" can be 0 thru 9 or A thru F) Faulty Seat Support OPDS Sensor

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 86-1 x or 86-2x indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures If another DTC is indicated, go to the DTC Troubleshooting Index. DTC List - Supplemental Restraint System

3. Check the connection at the OPDS sensor harness connector and the ODS unit connector.

Are the connections OK?

YES - Go to step 4.

NO - Reconnect the OPDS sensor harness connector, and erase the DTC.

4. Remove the front passenger's seat and replace the OPDS sensor/seat-back foam.
- 8-way power seat
- Manual seat
After replacing the OPDS sensor/seat-back foam, initialize the ODS unit.

5. Erase the DTC memory, then check for DTC 86-1 x or 86-2x.

Is DTC 86-1x or 86-2x indicated?

YES - Go to step 6.

NO - The system is OK.

6. Replace the ODS unit, and initialize the ODS unit .
7. Erase the DTC memory, then check for DTC 86-1x or 86-2x.

Is DTC 86-1x or 86-2x indicated?

YES - Replace the SRS unit.

NO - The system is OK.