ATF Cooler Outlet Hose Replacement

ATF Cooler Outlet Hose Replacement

1. Remove the ATF cooler outlet hose (A) from the hose clamp (B), then disconnect the hose ends from the ATF cooler lines.

2. Slide the ATF cooler outlet hose with the yellow paint end (C) over the ATF cooler line (D) on the transmission until the hose end contacts with the bulge (E).

3. Secure the hose with the clip (F) at 6-8 mm (0.2-0.3 in.) (G) from the hose end.

4. Slide the hose end (H) over the cooler line (I) on the ATF cooler under the radiator until the hose end contacts the bend in the line.

5. Secure the hose with the clip (J) at 2-4 mm (0.1-0.2 in.) (K) from the hose end.

6. Install the hose in the clamp at the mark (L).