Glove Compartment: Service and Repair

Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service Precautions before doing repairs or service.

NOTE: Take care not to scratch the dashboard or the related parts.

1. Open the glove box (A), and disconnect the glove box damper (B) from the pivot (C) of the glove box.






2. While holding the glove box (A), release the glove box stop (B) on each side from the dashboard by pushing them in. Disconnect the USB connector (C) and detach the harness clip (D) (for some models).






3. Remove the glove box (A).

NOTE: If you are only removing the glove box, go to step 5. If you are doing further disassembly of the glove box, continue to step 4.






Glove Box Damper Replacement

4. From under the dash, release the collar (A), then remove the glove box damper (B).






5. Install the glove box in the reverse order of removal, and make sure the connector is plugged in properly (for some models).