Do you have access to Mitchell1 Prodemand, or eautorepair.net DIY? If you are willing to share user/password (we can pay), please get in contact with us ASAP (truly, it is urgent): email operation-charm [[at]] tuta.io or click to submit anonymously
Power Mirror Motor: Service and Repair
Power Mirror Actuator Replacement
Power Mirror Actuator Removal and Installation
Removal
1. Remove these items:
- Mirror holder Mirror Holder Replacement
- Power mirror Power Mirror Replacement
2. Remove the gasket (A), then remove the screw and retainer clip (B) from the mirror (C).
3. Remove the cover (A).
4. Remove the three screws, separate the housing (B) from the bracket (C).
5. Remove the four screws (A) and separate the visor (B) from the actuator housing (C).
6. Remove the three screws (A) and the actuator (B) from the actuator housing.
Installation
7. Install the actuator (A) on the mirror frame (B), then tighten the three screws (C)
8. Install the visor (A), then tighten four screws (B).
9. Route the wire harness of the mirror frame through the hole in the bracket (A).
10. Reassemble the mirror in the reverse order of removal. Apply LOCTITE to the three screws (B) and tighten to 4.4 Nm (0.45 kg-m, 3.2 lb-ft).
11. Reassemble in the reverse order of disassembly. Be careful not to break the mirror holder when reinstalling it to the actuator Mirror Holder Replacement.
12. Reinstall the mirror assembly on the door.
13. Operate the power mirror to make sure it works smoothly.
Mirror Frame Removal and Installation
Removal
1. Remove these items:
- Mirror holder Mirror Holder Replacement
- Power mirror Power Mirror Replacement
2. Record the terminal location and wire colors, then cut the mirror actuator wires with a wire cutter.
3. Remove the gasket (A), then remove the screw and retainer clip (B) from the mirror (C).
4. Remove the cover (A).
5. Remove the three screws, and separate the housing (B) from the bracket (C).
6. Remove the four screws (A), and separate the visor (B) from the mirror housing (C).
7. Remove the three screws (A), mirror actuator (B) and mirror frame (C).
Installation
8. Install the actuator (A) on the mirror frame (B), then tighten the three screws (C)
9. Install the visor (A), then tighten four screws (B).
10. Route the wire harness of the new mirror frame through the hole in the bracket (A).
11. Reassemble the mirror in the reverse order of removal. Apply LOCTITE to the three screws (B), and tighten to 4.4 Nm (0.45 kg-m, 3.2 lb-ft).
12. Route the wire harness (A) of the new actuator through the hole in the retainer clip (B) and the gasket (C).
13. Insert the mirror actuator wires into their original terminal locations.
14. Apply cushion tape (A) to seal the wire harness.
15. Install the retainer clip and gasket in the reverse order of removal.
16. Reassemble in the reverse order of disassembly. Be careful not to break the mirror holder when reinstalling it to the actuator Mirror Holder Replacement.
17. Reinstall the mirror assembly on the door.
18. Operate the power mirror to make sure it works smoothly.