Transmission Range Switch Test

Transmission Range Switch Test

1. Remove the air cleaner assembly Service and Repair and the intake air duct.

2. Disconnect the transmission range switch connector.






3. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.

4. Transmission range switch test is completed if the test results are OK. If there is no continuity between any terminals, go to step 5.

Transmission Range Switch Connector





5. Remove the transmission range switch, and check the end of the selector control shaft (A).





6. If the measurement of the selector control shaft end is within the standard, replace the transmission range switch. Service and Repair If the measurement is out of the standard, repair the selector control shaft end, and recheck the transmission range switch continuity.