Cruise Control Combination Switch Test (With Cruise Control)

Cruise Control Combination Switch Test

SRS components are located in this area. Review the SRS component locations, Locations and the precautions and procedures, Technician Safety Information in the SRS before doing repairs or service.

1. Remove the driver's airbag. Drivers Airbag Replacement

2. Disconnect the 20P connector from the cable reel.






3. Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but the cruise control input test, indicated a faulty switch check and repair the wire harness on the switch circuit.

- If there is no continuity in one or more positions, replace the switch. Overhaul





4. Use a diode tester between the terminals according to the chart. If the diode fails the test, replace the switch. Overhaul