Condenser HVAC: Service and Repair

A/C Condenser Replacement

1. Recover the refrigerant with a recovery/recycling charging station A/C Refrigerant Recovery.

2. Remove the front grille cover:

- 2-door Front Grille Cover Replacement (2-Door)
- 4-door Front Grille Cover Replacement (4-Door)

3. Remove the intake air duct and the water separator Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation.

4. Remove the clips (A) and the air guide plate (B). Remove the bolts and the radiator upper mount brackets (C).






5. Remove the bolt, then disconnect the receiver pipe (A) from the A/C condenser.






6. Remove the bolt, then disconnect the discharge hose (A) from the A/C condenser.






7. Remove the coolant reservoir (A).





8. Remove the bolts, then remove the A/C condenser upper mount brackets (B). Remove the A/C condenser (C) by lifting it up. Be careful not to damage the radiator or A/C condenser fins when removing the A/C condenser.

9. Install the A/C condenser in the reverse order of removal, and note these items:

- If you're installing a new A/C condenser, add refrigerant oil (DENSO ND-OIL 8) Service and Repair.
- Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
- Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
- Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
- Be careful not to damage the radiator or the A/C condenser fins when installing the A/C condenser.
- Charge the system A/C System Charging.