Power Mirror Actuator Test

Power Mirror Actuator Test

1. Remove the door panel Service and Repair.

2. Disconnect the power mirror 6P connector (A) .






3. Check actuator operation by connecting power and ground according to the table.

Power Mirror Actuator





4. If the mirror fails to work properly, replace the power mirror actuator.

Defogger Test

5. Measure the resistance between terminals No. 1 and No. 3 of the 6P connector. There should be about 7 Ohms.

6. If the resistance is not as specified, check for an open in the wire between the connector and the mirror holder. If the wire is OK, replace the mirror holder.